Recent content by NoSlo5oH

What window switch rpm setting is everyone running for nitrous? What kind of ET are you guys running with those settings?

What is the procedure for performing a burnout with a line lock? I just completed the install on my JPC line lock and attempted to test it out with no success. The wheels did not spin at all and I smelled clutch material, so. I quickly aborted the attempted burnout. I should also add that I am...

I am in the process of installing my JPC line lock on my '13 GT and would like to know if the fittings are supposed to be torqued to a specific setting to prevent leaks? I haven't gotten that far yet, but wanted to see what everyone else's experience was with this kit. I also bought a JPC clutch...

Well, I went to Heartland Park Topeka Friday evening and made a few test hits. I knew going into this that I was at a disadvantage due to not having installed a line lock on the car. I was not willing to eat up my rear brakes to do a burnout, so I just did a quick hop prior to each run to clean...

Does anyone know which wires provide the preamp speaker signals for the Shaker Pro rear sub? There are three wires (besides the power and ground wires), in the amp connector (brown/blue, white/blue and gray with a burgundy or purple tracer). I want to feed the signal to my sound processor, so...

I am in the process of replacing the front and rear speakers in my 2013 Mustang with JL C2-570X speakers. I just test fit the rears and quickly discovered that they were smaller than the factory holes in the deck. I then measured the stock rear speakers and discovered that they're actually...

Can anyone tell me what this '98 Sean Hyland Motorsport built Cobra is worth? The odometer is showing 9,998 miles, but only 7,498 of those miles are on the built motor. Car went down the track 3 times back in 2000 and clicked off a 10.50 @ 136 on bigs and littles with slicks. 1998 Cobra SVT...

Thread moved to SN95 Cobra section.

Can anyone tell me what size the rear sway bar is on a '13 GT with Track Package is? I want to burn the factory bushings out of the support links and install poly bushings. I need to know what size bushing kit to order.

How many people are running M/T 28X12.5X15 ET Streets on their Mustang? I have a set waiting to go on my wheels whenever I get them. I bought them after seeing the following pics of a Boss on another forum with them. I tried sending the end user a PM, but haven't received a reply yet, so I...

How many people are waiting on SVE Drag Wheels? I ordered a set of black 17X4.5 and 15X10 wheels on 02/07/14 and they still haven't shipped yet. I noticed that the expected arrival date for more inventory kept getting pushed out further and further on their website, so I called and checked on...

I have a question for those of you who are running a UPR and/or Steeda brand bushing for the UCA in their rear end housing. Did you guys have free-play between the bushing inserts and inside rear portion of the UCA? I mocked mine up and noticed that there's about an 1/8" of play. I am trying to...

How many people are running the BMR sway bar relocate kit? I just purchased one and would like to know if the factory sway bar bracket needs to be cut flush with the BMR relocate brackets? All of the photos that I have seen shows the factory sway bar mount extending past the BMR relocate...

Is anyone using UPR axle braces? If so, how do you like them? Do you have plenty of clearance with 3" OTA pipes during full suspension travel? Was the install easy? Will you please post pics of them installed on your cars? Lastly, if you had to do it over would you buy them again...

I have a question for those who are running drag wheels. Did you require tune updates to compensate for the different size wheels in order to keep the speedo accurate?