I have seen prices in other areas range from 400-900. Not sure what the range is in this area. If you have some places in mind that are pretty reasonable at performing this type of install, let me know.
Hi guys,
I know it is has been a while since I have been/posted in here. The reason being my motor was blown up (Feb. 2014) while a dyno tuning session performed by Chris at Excessive Motorsports (also worked at IMA Motorsports).
I dropped off the car to him for a 2.3 whipple install...
I was curious if one had a whipple 2.3 with a stock tb inlet, and wanted to run the bbk twin 65 mm tb, would the inlet need to be ported? If so, who ports them? Thanks
Any locals want to meet up at the national harbor tonight in Md? We have a few cars already meeting up. If so, 10:15pm at mcdonalds/gas station. (sunoco I believe)
-Stock unported Eaton with 2.76 Billet flow pulley-pulley has only been on for 3k miles. perfect for getting ported-sold
-Stock Tb and plenum -sold
stock 39lb injectors -$125
Buddy of mine just purchased an 2010 Audi R8 the v10 version. I was going to run him just to see how my car does. What you think is my best race? Dig is probably out of the question since I am terrible off the line. What mph roll race?