Recent content by milktasd2

  1. milktasd2

    Loosing Motivation

    It tried to sell mine a couple of times, currently it’s out of sight out of mind. It’s over at the painters being neglected. Every stage of my build has taken way longer than it should that I don’t even care anymore. I got too much in it to really sell it and I would like to feel boost before I...
  2. milktasd2

    The Official Centrifugal Pulley/Boost Combo Thread!!!

    some pretty good numbers for switching to auto. So you thinking of porting the stocker? Going ported short runner? Going all out like a Sullivan or other aftermarket? I bet that power feels good
  3. milktasd2

    Went to the Texas mile with a foxbody.

    179 is moving for the half.
  4. milktasd2

    Went to the Texas mile with a foxbody.

    Makes 890rwhp on pump gas and meth on 12 lbs of boost. Foxbodies aren’t very aero friendly, which isn’t helping, and he is going into overdrive right after the quarter so he had to lift, wait for the car to shift into overdrive and then floor it again which was slowing it down too. The car was...
  5. milktasd2

    Went to the Texas mile with a foxbody.

    Right now it’s in body shop hell for a while. It has teksid block, forged bottom end, ported 04 heads, custom cams, t56, vortech JT trim, fore fuel system, id1300 , flex fuel and running on Holley hp. Whenever it gets painted, I plan on swapping the interior to black and then breaking in the motor.
  6. milktasd2

    Went to the Texas mile with a foxbody.

    Went with a couple of friends to the Texas mile. One ysi sbe ls3 grandsport and one 1990 mustang gt with a ls 402, ysi, 4l80. Ran into an issue with the car not wanting to go into overdrive at WOT, so that definitely hurt us and weren’t able to fix it that weekend. Pretty happy with how well it...
  7. milktasd2

    HELP ! SMART COIL HELP

    A lot of people remote mount them. I mounted mine in my fenders since my Holley coils didn’t clear either.
  8. milktasd2

    99 Cobra Pro Charger FMIC on a 98 Cobra?

    I’m no expert, but I would say yes. The cxracing kit I got said good for 94-04, would assume the same for the one you are looking at.
  9. milktasd2

    CX Racing Intercooler 96-98 Cobra

    Not really, I for some reason didn’t want to cut a hole in the frame for the pipes to go through, so just used the one existing hole where the air filter used to be.
  10. milktasd2

    CX Racing Intercooler 96-98 Cobra

    I used cx racing pipes and tread stone intercooler. Be prepared to buy some extra elbows depending on how your route it.
  11. milktasd2

    1997 Mustang 4.6 Vortech 18psi reaching 250 F and up when using A/C

    I disagree about the ac wouldn’t cause the vehicle to run hot. When the ac is hot, heat from the condenser is going to be hitting the radiator adding extra heat. I know, same thing happens to my daily Sonoma. I can’t run ac in 5oclock traffic in the heat of the summer because coolant temps will...

Top