I have a pair of 11 5/8 Brembo rear rotors been sitting round for years, so I went and tried putting them on today.
These are too big for the rear. Is it possible to find a caliper kit which pushes out the caliper bracket out a 1/4 inch or so?
Or would a Cobra caliper bracket work?
150 a month is a lot for where you worked. Must have kept you very busy. Yet you base your fact that Teslas don't get stolen on the area you worked, ok. Might be there wasn't a demand there? Don't know, not some stolen vehicle cop.
Right now they are being stolen at a much lower rate then...
Tesla car hacked using drone; a patch has already been released - Electrek
Researchers Hacked And Stole A Tesla Model X In Just Minutes (forbes.com)
The Big Tesla Hack: A hacker gained control over the entire fleet, but fortunately he's a good guy - Electrek
These would be just a few links...
I was having the same question like the OP with the 03/04 Cobra heads. So to be clear the 4 threads there is really no issue and the 4 to 9 conversion (while the heads are off) is good to get long as its a "lock n stitch".
I have one custom made stainless steel Ice Box / Cooling Reservoir. Located in Connecticut. This was going to go in my 2001 GT with a twin screw supercharger in 2012. Went turbo instead and now this needs a home. $400.00 shipped. I use pay pal and if money sent through pay pal send as gift...
Mods if in wrong place please move.
I've put my Teksid block build off for bout ten years. Focused on paying off the house. Now if nothing pops up, time to get back to it.
Talking to a buddy last year and he was telling me he had 03/04 Cobra heads sitting by his garage. Wound up he told me if...