Comes complete with alt pulley.
KEEP IN MIND FELLAS THIS WILL ALSO WORK GOOD TO PREVENT BELT SLIP WITH A LARGER UPPER PULLEY. I think people are only thinking adding this to a dinky upper pulley will make too much boost.
$300
785-331-7593
[email protected]
Not very old and comes complete. I keep getting an error message while uploading the pic so either I can email it or text it.
$300
[email protected]
785-331-7593
Johnnys Porting Service eaton #163
Afco triple core heat exchanger
Oversized aluminum reservoir
Couple billet flow idler pulleys
Billet flow quick change 2.93 blower pulley
SCT 2600 MAF
JLT rai setup
New Ford OE alternator
Accufab single blade and plenum
It will come with everything...
Been chasing this for a month guys!!
10:1 comp, long tubes, ported eaton on 17#, sumped tank magnafuel 750 on e85. 80# injectors. Fuel pressure idle 40 psi-65psi WOT. 5 speed manual tranny.
Nitrous system is NX with dynotune tomahawk nozzle mounted in intake tube about 2" before TB...
I've tried to figure this out for over a year! Last year installed AJE k member which is only available with solid motor mounts. Noticed an 1800 rpm vibration after install. Over the winter built a teksid forged short block. Balanced entire rotating assy with flywheel, clutch, and balancer...
Hey guys ran into a bit of a snag. Im building a teksid setup with factory 03-04 Cobra Eaton and front dress. I was running that exact setup on my 04 Mach and was using the stock Mach water pump. I decided while its apart I would replace the pump. Heres my issue.......the part number for a Mach...
E85 Running dual stealth 340's in stock cobra hat so running (2) -6 out about 12" to Y block then -10 fuelab and rest of the way up. Running big Holley regulator then Y's out after reg to -8 to each aeromotive rail. -8 return all the way to the hat and then -6 fitting on the hat to dump in. I'm...