2013 Trinity Supercharger with factory elbow and VMP quick change pulley hub (no pullies). Blower was painted semi gloss black with engine enamel, still in good shape. One vaccum port on the blower and the evap port on the elbow is tapped and plugged. Plugs can be removed if you would like to...
I am looking for a knock sensor harness for a 2010 to 2014 GT500. Ford has discontinued the part number so I can't buy it from the dealer anymore. The part number is AR3Z-12B559-AA.
Any help would be much appreciated!
Looking to maximize a TVS on my 07 GT500 setup.
How would these two compare? I have a Trinity already, and I a trying to decide which way to go.
I want to make an easy 700rwhp through an auto? Realistic goal, or would a larger twin screw make more sense. Stock long block.
I have for sale a bell housing, Ram twin disc clutch and aluminum flywheel setup, and aluminum Cobra drive shaft without the slip yoke. The bell housing comes with the clutch fork as well, but the middle starter bolt hole has been drilled out to just use a bolt and nut on it. The clutch and...
I have for sale the t56 set up out of my Modular swapped foxbody. It comes with the stock bellhousing, transmission, Ram twin disc clutch, Steeda Triax shifter, trans mount, clutch fork, aluminum flywheel, aluminum cobra drive shaft and trans wiring harness.
The Trans was pulled out working...
How far can a stock 2007 GT500 long block be reliably pushed power wise through an auto? I obviously don't want to have to worry every time I get on it though either. The engine is actually in a 3300lb foxbody also, and I am thinking about putting a 4r70w or 6r80 behind it. Thank you for the...
Dropping a feeler for my low mileage Trinity blower. It comes with 2013 fuel rails, 2013 injectors, elbow, and VMP quick change 2.5 pulley and hub.
The blower is painted black with an engine enamel spray paint, it is not powdercoated. The finish does look very nice though. It is still on my...
I have some parts for sale that came off of an 07 GT500 engine with only 5300 miles on it. The engine got swapped into my 86 mustang, and the parts from that motor I am selling are leftovers due to a trinity swap. The 2013 parts I am selling were included in a trinity take off package I...
2007 and 2013 GT500 Engine Parts: supercharger, thermo housing, fuel rails, etc.
I have some parts for sale that came off of an 07 GT500 engine with only 5300 miles on it. The engine got swapped into my 86 mustang, and the parts from that motor I am selling are leftovers due to a trinity swap...