Yesterday morning I go out to start my car to go to work and it fires for about 10 seconds then dies. So I try recranking it and it just turns and turns and turns. No fire. Didn't have time to work on it cause I had to get to work so I grabbed my wifes car and when I got home I unhooked the...
$250 OBO shipped. 1 credit/vin used.
Willing to sell with UPR O/R X pipe for $300 total. X pipe will sound great and perform even better with a tune. And no CEL light to worry about.
2 1/2" inlet/2 1/2" outlet. Offset SI/SO. $85 shipped for both or $40 a piece + shipping. PM w/offers if you want to pick up :woot:
These are LOUD and were way too loud with my UPR O/R X pipe. Not too bad with the stock midpipe though. I switched over to Pypes Violators instead...
Anyone have these mufflers? Preferably with a UPR O/R X? I'll be installing them on Sunday and I wanted to see if I could see what they would sound like before I do
Is it pretty easy to piece together a Procharger or Paxton setup?
I see head units sold all over the place but can you pick up a headunit and swap mounting brackets? Also what all is needed for a centrifugal setup?
1997 Mustang SVT Cobra
Black Exterior
Black Leather Interior
Black Cobra Wheels
133xxx miles
78xxx miles on new Mark VIII shortblock (same motor just has 6 bolt cast crank instead of forged, still good for about 400-425 RWHP)
255/40/17s up front (40% tread left)
275/40/17s in the rear...
Final product turned out great in my eyes. Let me know what you guys think.
started with just drilled and slotted rotors that were on the car when I bought it.
Did a light sanding after taking the rotor off
Put vaseline over the COBRA letters and then sprayed 4 coats of high temp flat black...
I'm in the middle of tearing down my brakes to polish my calipers and I was wondering how do I disconnect the brake fluid line from the caliper?
Also can I do a very light sanding on my rotors themselves with like 600 grit?
O/R X and single chamber Cherry Bomb Extremes is just too loud of a setup. Thinking about putting stock GT500 mufflers on since they are made by Borla. Anyone think this will actually sound pretty good still when I step on it? I don't want to quiet it down TOO much but I'm going to be...
anyone bought used tires off ebay before? I'm trying to save some money because I can get the 2 tires I need for half the price of new and they look great. What have your experiences been with this? Let me know. Thanks guys
So to start off I have a mark VIII shortblock now and the guy that did the swap for me told me later that he stuck a V6 flywheel on it and I think that's the reason to my bad vibration. I know our engines are internally balanced but if the V6 flywheel is weighted differently (I'm not sure if it...
1997 Black on Black Mustang SVT Cobra
Black w/black leather interior
123xxx miles
Pioneer 5000 headunit with full ipod control (also can be bluetooth compatible with optional unit from Pioneer for less than $100)
255/45/17 front
275/40/17 out back (less than 5k miles)
UPR Off Road X pipe w/...
I made a rookie mistake last night while trying to re-wire one of my speaker connections. I didn’t disconnect my battery and one of my open wires from my wiring harness adapter for my pioneer either touched the same ground I have for my stereo or it touched another power wire and now I have the...