Spoke to BMR again today. They have stopped production on them and have revised the jig. Arrapently they have found that the rear plates are about an inch too short, exactly what I was seeing too. I have also informed them about the height and header clearance on the pass side.
Mine us heading back to them tomorrow, hopefully. Hurricane ZETA put a pretty big hurting on new orleans last night and we are out of power everywhere.
They said the plan is to have the jig redone and have longer plates built. Obviously I won' know this until I get a new one back in my hands.
I'll update things as I know them
Nice, I emailed them yesterday and referenced the thread and showed photos of my measurements. If they don’t get back to me in the next couple days then I’ll call them.