I am thinking about freshening up the Cobra with a new valve job and new springs. While I was in there I thought I would put in a x303 I have lying around. Does anyone have any experience or thoughts? Plus I was curious about valve clearance. TIA
Thanks alexs93lx
That seems to be the consensous. I guess I will have to use a different cam. I am just surprised because CCM uses that cam in almost every shortblock they sell even with GT40P heads.
call up Dennis Hilliard at CCM he is a X-303 guru. It is a nice cam if it is installed properly which dennis will tell u is 8degrees retarded. E303 will make a decent amout of power with the factory cobra heads/intake due to thats the combo it was designed for.
Thanks tommygun
I probably should have consulted with CCM first but I ended up going with a 2031 with the spring kit . For the price and simplicity I couldn't pass it up.
You can run the X-cam......They have a valve relief tool that bolts to the block and allows you to make bigger valve relief's in the pistons to run that cam with a stock motor. If you are going to freshen the motor go ahead and change the pistons. The price of J&E pistons have come way down they run no more than $400. You can get any compression ratio to make the cam work in the enviorment in which it was designed. Great cam!!! It just needs the right compression (10.5)still pump gas or retard 6 degrees and strap on a blower. Used the cam and had about 10.8:1 ran awesome when it was striaght up then degreed the cam and it was an animal.