This is an extremely fast car. it runs very consistent.on the motor alone it will run the quarter mile in [email protected] thats was not a hail marry pass either.it runs it everytime.i dont drive it on the street that much,but it will do it without a prob. car never runs over 180*.i just installed a new 6" Harwood cowl hood on it with 2 new sets of pins.car has a N.O.S Fogger system on it,with a dual purge up the winshied.the car has NEVER been bottle'd. based on similar set-ups that we have done in the past the car should cover the 1/4 on the bottle in the low 9 second range without a prob. the body and paint of the car looks great.in the pics below you will see the car has gone threw a couple of changes.there use to be tribal graphics down the side.which are now gone.you will also see the old hood,which was a 4" cowl with an 82 scoop on top of that.the most current pics of the car are the ones with the black 6" cowl(last week)....but all the pic's are from this past summer.there is well over 25k invested in this car.
if you have any questions please call my cell 314-565-0415...Ryan
here is a few video's of the car...please follow links...these are motor pass's...NO nitrous
http://www.youtube.com/watch?v=bMHszOorRUE
http://www.youtube.com/watch?v=HhbQ_ldz0jA&NR=1
as for the go fast parts
393 Windsor Balanced rotating assembly
79 truck block, 79 truck rod
Scat crank
Arp studs on mains and heads
D&D Tubular A arms, K-member & Coil overs
Victor Jr aluminum heads
Motorsport Intake
Je forged pistons
10.0:1 Compression Ratio
830 PROSYSTEMS carb (brand new) about 5 miles on it.just cost me $700
Electric water pump aerospace dynamics
C4...just rebuilt...50 miles ago
JW transbrake-double pull double throw relay wired in to activate nitrous when transbrake is released
Aluminum driveshaft
Front and Rear driveshaft loops
33 spline Strange
superlite spool
C-clip eliminators
Jegs adjustable lower control arms
Boxed uppers alum.
10 gal fuel cell
NOS sportsman fogger kit
msd 6al
3 stage retard
2 step
girdle
250 260 @ .050 568 592 lift 106 lobe separation 106 lobe centerline
1.6 crane gold rockers
Braided AN lines throughout
Rear seat delete
Chromemoly 6 point cage
Subframe connectors welded into cage
4200 stall Neal Chance 9’ torque converter weakest part made to hold 1800 horse anti-ballooning plates for nitrous. I anhilated the last converted so went overboard on this one so it will not ever break with this current setup.
Custom Dash with Autometer gauges
Cowl Gauge Concepts cowl with fuel and nitrous gauges
Catch can
Barry Grant Fuel Pump
Percy's Digital Exhaust Temperature Indicator--left and right banks
Tinted windows
3 inch off road pipe with 40 series flows for driving car on street
Fuel pressure and Oil pressure Safety lites on tach
Aluminum Radiator
Strange 10 position shocks
Bracket relocation kit
Airbag in Right rear
Weld Drag magnum 2.0's with Mickey T's 26X10 with good rubber left
Brand new 6" Harwood Cowl.
$13,000
Thanks for looking
Ryan
the black car is my turbo car and its not for sale
if you have any questions please call my cell 314-565-0415...Ryan
here is a few video's of the car...please follow links...these are motor pass's...NO nitrous
http://www.youtube.com/watch?v=bMHszOorRUE
http://www.youtube.com/watch?v=HhbQ_ldz0jA&NR=1
as for the go fast parts
393 Windsor Balanced rotating assembly
79 truck block, 79 truck rod
Scat crank
Arp studs on mains and heads
D&D Tubular A arms, K-member & Coil overs
Victor Jr aluminum heads
Motorsport Intake
Je forged pistons
10.0:1 Compression Ratio
830 PROSYSTEMS carb (brand new) about 5 miles on it.just cost me $700
Electric water pump aerospace dynamics
C4...just rebuilt...50 miles ago
JW transbrake-double pull double throw relay wired in to activate nitrous when transbrake is released
Aluminum driveshaft
Front and Rear driveshaft loops
33 spline Strange
superlite spool
C-clip eliminators
Jegs adjustable lower control arms
Boxed uppers alum.
10 gal fuel cell
NOS sportsman fogger kit
msd 6al
3 stage retard
2 step
girdle
250 260 @ .050 568 592 lift 106 lobe separation 106 lobe centerline
1.6 crane gold rockers
Braided AN lines throughout
Rear seat delete
Chromemoly 6 point cage
Subframe connectors welded into cage
4200 stall Neal Chance 9’ torque converter weakest part made to hold 1800 horse anti-ballooning plates for nitrous. I anhilated the last converted so went overboard on this one so it will not ever break with this current setup.
Custom Dash with Autometer gauges
Cowl Gauge Concepts cowl with fuel and nitrous gauges
Catch can
Barry Grant Fuel Pump
Percy's Digital Exhaust Temperature Indicator--left and right banks
Tinted windows
3 inch off road pipe with 40 series flows for driving car on street
Fuel pressure and Oil pressure Safety lites on tach
Aluminum Radiator
Strange 10 position shocks
Bracket relocation kit
Airbag in Right rear
Weld Drag magnum 2.0's with Mickey T's 26X10 with good rubber left
Brand new 6" Harwood Cowl.
$13,000
Thanks for looking
Ryan
the black car is my turbo car and its not for sale
Last edited:
