http://www.southfloridapulleyhq.com/SFPH/cobra/ie_powerstack_filter.htm
Might be a dumb question not sure though
Might be a dumb question not sure though
Will this Air Filter fit a New Edge?
- Thread starter StevesBuddyAntz
- Start date
It might slip on the MAF. Just buy a CAI or don't.
Huh?VirtualSVT said:
It won't fit in the filter housing. I'm not sure if it will slip over th mass air meter and even if it does it will be in the engine compartment sucking in hot air.
I'd get a K&N filter that fits in the stock housing before I bought an open filter. But you are dropping 50 bucks and could put that towards the cost of the CAI.
I'd get a K&N filter that fits in the stock housing before I bought an open filter. But you are dropping 50 bucks and could put that towards the cost of the CAI.
Got ya...thx
Buy my JLT RAI :-D
99cobraR said:
what u asking for it?
VirtualSVT said:
i am so sick of hearing this faulty logic...
that looks like the same filter that comes with the JLT RAI, but you'll need the adapter flange to make it work with the stock MAF...they're like 20-25 bucks, so you might as well buy the JLT RAI, which would only be about 80 bucks more (total of like 160 i believe)...
Does either of the JLT unit's need a tune to reach the advertised power?...I hear they go rich because the piping is so big.
the only reason i could see it going rich or lean is if the clocking of the maf affects the reading of the sensor...if your flow density is altered from stock your a/f will be affected, but probably by a negligible amount...
Users who are viewing this thread
