Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
SVTPerformance's Chain of Restaurants
The Distillery
Whipple 3.4 E-70 Dyno Results
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="04torchred" data-source="post: 10559656" data-attributes="member: 23761"><p>The 01 cams run more duration then stock 03-04 Cams on the intake side so he should have gained with those. I believe they are 200 duration at 0.050. Where were the cams degreed in at? What is your intake and exhaust cam centerline?</p><p></p><p>Did you compress all the lash adjusters before sticking them back in the heads to make sure you don't have any that are collapsed or not able to bleed down(this could buggar valve seal and lead to less power). I have found 3 collapsed lifters on my brothers engine already and 2 that won't bleed down. I still have 10-12 lash adjusters to go.</p><p></p><p>What are your IAT2 temps on the blower at the end of a pull. If you are stock inlet with stock manifolds you might be wise to back the boost down to keep the temps in check as you will have a good bit of heat in the combustion chamber. </p><p></p><p>Exhaust is holding it back, but not the reason for only 700 at 26psi.</p><p></p><p>How big is your air filter?</p><p></p><p>I was able to make 685rwhp/605rwtq with a 6.55" lower and 3.5" lower with pump gas and torco and 20.5* timing on a stock longblock.</p></blockquote><p></p>
[QUOTE="04torchred, post: 10559656, member: 23761"] The 01 cams run more duration then stock 03-04 Cams on the intake side so he should have gained with those. I believe they are 200 duration at 0.050. Where were the cams degreed in at? What is your intake and exhaust cam centerline? Did you compress all the lash adjusters before sticking them back in the heads to make sure you don't have any that are collapsed or not able to bleed down(this could buggar valve seal and lead to less power). I have found 3 collapsed lifters on my brothers engine already and 2 that won't bleed down. I still have 10-12 lash adjusters to go. What are your IAT2 temps on the blower at the end of a pull. If you are stock inlet with stock manifolds you might be wise to back the boost down to keep the temps in check as you will have a good bit of heat in the combustion chamber. Exhaust is holding it back, but not the reason for only 700 at 26psi. How big is your air filter? I was able to make 685rwhp/605rwtq with a 6.55" lower and 3.5" lower with pump gas and torco and 20.5* timing on a stock longblock. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
SVTPerformance's Chain of Restaurants
The Distillery
Whipple 3.4 E-70 Dyno Results
Top