Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Lightning Forums
Harley-Davidson™ F-150
What size pulley and where to get pillar and gauges from?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="oki" data-source="post: 10895201" data-attributes="member: 97829"><p>If you are DDing the truck I would stick with either a 4# or 6# lower at the most. Change you plugs out to NGKTR6's when you change the pulley and get a new tune done. </p><p></p><p>The block can handle it no problem, but just be careful of the NO NO's as the rods are your week point.</p><p></p><p>--- No 2 gear kickdowns</p><p>--- No WOT blasts into OD, make sure OD is off if you go WOT</p><p>--- No WOT blasts in colder weather (I say 55* or lower) as the cold dense air will up your boost</p><p></p><p>As for getting a pillar pod --- search the boards for guys selling theirs...its usually the cheapest and easiest way to get a good one. Hard part is deciding if you want a 2 or 3 gauge pod.</p><p></p><p>Guages are going to be personal preference for design & color options.</p><p></p><p>I personally run Autometer Cobalt Blue Gauges, Black Face, Chrome Bezel for my Boost(located on steering column in pod) and Water Temp (cut hole in radio bezel on driver side below vent and mounted), Autometer Chrome bezel, white face Wideband and Dual Interceptor in my Triple Pillar Pod.</p></blockquote><p></p>
[QUOTE="oki, post: 10895201, member: 97829"] If you are DDing the truck I would stick with either a 4# or 6# lower at the most. Change you plugs out to NGKTR6's when you change the pulley and get a new tune done. The block can handle it no problem, but just be careful of the NO NO's as the rods are your week point. --- No 2 gear kickdowns --- No WOT blasts into OD, make sure OD is off if you go WOT --- No WOT blasts in colder weather (I say 55* or lower) as the cold dense air will up your boost As for getting a pillar pod --- search the boards for guys selling theirs...its usually the cheapest and easiest way to get a good one. Hard part is deciding if you want a 2 or 3 gauge pod. Guages are going to be personal preference for design & color options. I personally run Autometer Cobalt Blue Gauges, Black Face, Chrome Bezel for my Boost(located on steering column in pod) and Water Temp (cut hole in radio bezel on driver side below vent and mounted), Autometer Chrome bezel, white face Wideband and Dual Interceptor in my Triple Pillar Pod. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Lightning Forums
Harley-Davidson™ F-150
What size pulley and where to get pillar and gauges from?
Top