shit was not was not coming to gether and i was not just going to tighten the hell out of the v-clams
What hp will i get ? Saleen stroker kit, On3performance turbo
- Thread starter cody44mathis
- Start date
so i pulled out the hack saw and the tig welder cut the down pipe and re clocked it
and i cut the pipe that crosses over that connects to the down pipe
and i cut the pipe that crosses over that connects to the down pipe
now for the intercooler
coolant pipe did not line up eather. cut and tig to make fit
DIY fuel hat. took some messuring, ss angle iron, hose clamps, 6an fittings, barbed fitting, piece of rubber fill hose, ford gt pumps
Last edited:
fuel sytem is stainless hard line. duall 3/8 to one single 1/2 then back to dual 3/8 to the steeda fuel rails
going up the fender well car
Users who are viewing this thread
