What head gaskets with teksid block and 03/04 heads

[texas_snake]

So I should be getting my teksid block ready to go from the machine shop in about 1 - 2 weeks. I have been looking to pick up parts with all the savings going on right now. I want to use fel-pro mls head gaskets for the build. But it is hard to know what will work. There are lots of fel-pro part numbers for 4.6 mls gaskets. The different part numbers I see are:

03/04 Cobra: 26222 PT / 26187 PT
03/04 mach 1 (should be same head as 03/04 cobra): 26217 PT / 26188 PT
96-98 Cobra (since teksid block): 9792 PT-2 / 9790 PT-2
Lincoln Mark VIII (since teksid block): 9792 PT-2 / 9790 PT-2

Engine is bored to 3.5720, but I believe these gaskets are 3.6 bore.
Also I don't know if there is any difference in compressed thickness.

Ideally I would be able to use the 03/04 Cobra VIN Y gaskets with the teksid block. But no clear info on which way to go here. Also I don't have the head cooling mod on the back, but I assume the gasket for 4v heads with Teksid does not matter as far as cooling passages.

Thanks.

 

[texas_snake]

Perhaps let me rephrase the question.

For those with Teksid builds, were you able to use 03/04 Cobra head gaskets without modification?

Thanks.

 

[shurur]

I don't wish to get in trouble with SVTP...but..
You should post your question here:
NA SVT Camshafts, Modular Tech Group Public Group | Facebook

Todd (na svt) Warren is the mod motor guru.

But...Some of the same folks who post there post here as well.

 

[badcobra]

Use the 26187PT and 26222PT, that is what I run with a teksid. 35+ lbs boost and 1500+ whp.

 

[Shadow Grey 03]

Use the 26187PT and 26222PT, that is what I run with a teksid. 35+ lbs boost and 1500+ whp.

Are you sure those will hold?.....hahahahaha. I'd say BadCobras response is what you need here.

 

[texas_snake]

OK great. The 03/04 Cobra head gaskets with 03/04 Cobra heads will work without modification on a teksid block - And clearly they HOLD ON HIGH BOOST! Great to hear.

Thanks much.