So last night I went to start up my cobra that I just finished building and the msd dis-4 started to smoke so I turned the key off and ended up having to rip it out as it was mounted in the engine bay. I was wondering what is the best msd to run as I am looking into purchasing another one. The reason it started to smoke I am thinking is because it got moisture/wet inside the box. My mods are:
-V1 SC trim blower
-31x12x3 fmic
-TurboXS RFL BOV
-VMP 75mm MAF tube
-255lph pump
-screamin demon coil packs
-live wires 9mm performance wires
-msd dis-4 digital ignition :mj::mj:
-eaton posi with 373 gears
-31 spline mosers
-pro 5.0 shifter
-bassani x pipe no cats
-bassani catback
-bassani mid-length headers
-spec stage 3 clutch
-Accufab Single Blade Throttle Body
-Crower stage 3 sc cams
-manley .020 over pistons flat tops
-crower valve spring with steel retainers
-manley h beam connecting rods with 22mm pin
-ford racing high performance oil pump
-ford racing mustang oil pan
-60 lb injectors flow matched
-high performance 3 angle valve job
-polyurethane motor mounts
-built t-45 tranny (t-45 source)
-V1 SC trim blower
-31x12x3 fmic
-TurboXS RFL BOV
-VMP 75mm MAF tube
-255lph pump
-screamin demon coil packs
-live wires 9mm performance wires
-msd dis-4 digital ignition :mj::mj:
-eaton posi with 373 gears
-31 spline mosers
-pro 5.0 shifter
-bassani x pipe no cats
-bassani catback
-bassani mid-length headers
-spec stage 3 clutch
-Accufab Single Blade Throttle Body
-Crower stage 3 sc cams
-manley .020 over pistons flat tops
-crower valve spring with steel retainers
-manley h beam connecting rods with 22mm pin
-ford racing high performance oil pump
-ford racing mustang oil pan
-60 lb injectors flow matched
-high performance 3 angle valve job
-polyurethane motor mounts
-built t-45 tranny (t-45 source)
