tryin to figure out what intake i should run i want to do a cam,heads and an intake this winter and then next fall go with a vortech what would u guys suggest or what do u guys run thanks
erick
erick
wat intake???
- Thread starter rikhockey
- Start date
stock cobra has worked fine on my setup. Trickflow intakes are good also
holley or canfeild!
truepsucobra said:
im thinkin about AFR 165 or 185 and then the preformer RPM2 intake thanks for the info didnt think anyone was going to chime in with there ideas thanks erick
Im still running the cobra intake and 19psi
stock cobra intake, 14 psi.
536/528 running a little dangerous with the a/f.
525/532 is what I come home with
536/528 running a little dangerous with the a/f.
525/532 is what I come home with
Wassup man---never noticed your post :coolman:
AFR 185s and RPM2 is my vote...but you already knew that :rockon:
That combo and a cam more for a blower might be softer at lower rpms on the 302, but you will see BIG gains with the Vortech or 347.
Next time your over look at the new MM&FF mag...it has an RPM2 with the edelbrock name sanded down. I think the '93 Cobra intake plate will look sweet there, but you already know that too.
I can't wait till you get the charger...... :burnout:
Go rob a bank and we'll do it all at once.
Later, J
AFR 185s and RPM2 is my vote...but you already knew that :rockon:
That combo and a cam more for a blower might be softer at lower rpms on the 302, but you will see BIG gains with the Vortech or 347.
Next time your over look at the new MM&FF mag...it has an RPM2 with the edelbrock name sanded down. I think the '93 Cobra intake plate will look sweet there, but you already know that too.
I can't wait till you get the charger...... :burnout:
Go rob a bank and we'll do it all at once.
Later, J
Users who are viewing this thread
