Black94svt
New Member
The motor is a 351 based block with probe pistons, scat stroker kit, arp head studs, afr 205 heads cnc ported. Studs have main girdle on bottom end. The cam was custom grind solid roller by anderson cams with .625 lift on intake and .625 on exhaust. The carb will be a prosystems custom 850 cfm. Centerforce dual friction clutch with a quicktime sfi bellhousing and tremec tko 600. Everything down to every nut and bolt is new. The compression on the motor will be 10.2:1, the rockers are harland sharp 1.6 ratio with the girdles. The list goes on and on. So what do you think about this setup and what should it run and how much horsepower do you think it should make. Its a 408 cube stroker and the cam will hold 7000 rpm. The car will be fully gutted and weight in around 2800. I can finish car so its running. This car has cost me alot of money because i bought the best of everything.
