Vortech Maxflow Race BOV

lovebread

Member
Established Member
Joined
Jun 25, 2013
Messages
340
Location
Santa Clara, CA
I think this would be a great upgrade for anyone who doesn't want to spend the 400+ it takes to get a Tial Q under the hood.

There is zero performance increase going to a Tial Q.
 

lovebread

Member
Established Member
Joined
Jun 25, 2013
Messages
340
Location
Santa Clara, CA
Unfortunately most of them range from split seconds to potato quality. I've never been outside my car to hear it running!

First few seconds
[video=youtube;uOKCwKAJLUI]https://www.youtube.com/watch?v=uOKCwKAJLUI[/video]

You can hear it a little on the bleedoff here, easily louder than every other dinky exotic. Skip to 25:45 because this forum doesn't support time.


[video=youtube;W9uesQqGNtM#t=1547]https://www.youtube.com/watch?v=W9uesQqGNtM[/video]
 
Last edited:

lovebread

Member
Established Member
Joined
Jun 25, 2013
Messages
340
Location
Santa Clara, CA
[video=youtube;lE9zUv6hkyo#t=53]https://www.youtube.com/watch?v=lE9zUv6hkyo#t=53[/video]

Here's a drive by @ 52s
 
Last edited:

lovebread

Member
Established Member
Joined
Jun 25, 2013
Messages
340
Location
Santa Clara, CA
And do you have a picture of this?

At the moment no, I am awaiting the part back from Vortech.

It honestly might not come until next week at this rate so I don't want to get anyone hope's up. If the buyer wishes I can probably get it directly shipped to them.
 

lovebread

Member
Established Member
Joined
Jun 25, 2013
Messages
340
Location
Santa Clara, CA
Fm1KfXM.jpg


They are sending me a brand new one back.

Why did it go to Vortech, was it rebuilt? What was wrong with it?
Wasn't it on the way when you posted it?

Part went right to Vortech for analysis after I tested it. Car was dead for basically 2 weeks while I waited for fabrication of JPC Tial Q 50mm pipe.
 
Last edited:

Users who are viewing this thread



Top