20-COBRA-03
Banned
hey guys... i'm a little lost on the routing of my vacuum lines for my gReddy spec 2 electronic boost controller, tial waste gate, and tial blow off valve... i would greatly appreciate anyone lending a few mins of their time to tell me how the vacuum lines are ran... no need for detailed instructions... i appreciate it... i'm quick to understand... i'm guessing that i need to run the vac lines like this...
1... common side of greddy valve unit to top port of waste gate.
2... opposing side of greddy valve unit to fitting on turbo compressor housing.
3... vacuum line off of greddy controller, to Y fitting, to both FPR vaccum and intake vaccum.
4... remaining WG and BOV ports ran to seperate intake vacuum sources.
does that sound right to you guys? thanks in advance
1... common side of greddy valve unit to top port of waste gate.
2... opposing side of greddy valve unit to fitting on turbo compressor housing.
3... vacuum line off of greddy controller, to Y fitting, to both FPR vaccum and intake vaccum.
4... remaining WG and BOV ports ran to seperate intake vacuum sources.
does that sound right to you guys? thanks in advance
