Upper control arm for 1 piece?

[Molonlabemike]

I so just installed a new Dynotech one piece driveshaft and after spinning it around the block I noticed a slight vibration under acceleration. Being that the only suspension item I have is lower control arms would I need an upper to correct my pinion angle?

Didn't think I would have any vibs since I was stock :nonono:

 

[Ron Mexico]

Reclock your driveshaft.

 

[Molonlabemike]

Reclock your driveshaft.

So unbolt it and turn it 180 deg?

 

[Ron Mexico]

So unbolt it and turn it 180 deg?

Yep. If that doesn't cut down the vibes, you can also clock it left or right 90 degrees. I have the same ds and my NVH went down after install.

 

[beefcake]

more than likely you will need an uca, best thing to do is measure it and go from there. that's the right way to go about it

 

[Molonlabemike]

more than likely you will need an uca, best thing to do is measure it and go from there. that's the right way to go about it

What's the correct pinion angle for our cars?

 

[Ron Mexico]

more than likely you will need an uca, best thing to do is measure it and go from there. that's the right way to go about it

He's not lowered so his pinion angle should be fine. OP, reclock the ds before buying more parts to band aid the problem.

 

[beefcake]

just assumed lowered, if reclocking doesn't work, give the co a call