Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Lightning Forums
2nd Generation
trashcan heat shield mod
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Robert Francis" data-source="post: 8611660" data-attributes="member: 3393"><p>If you're talking about the "trash can" air box, theres not much too it. </p><p></p><p>I've made a couple up over the past 6-7 years. I used a "Rubbermaid" trash can - don't recall the size - but you can tell the right size by looking at one. With the stock air box removed it's not hard to visulize how to make the trash can fit in there. I already had removed my stock airbox and had a cone filter adapter on my MAF. I just cut one side of the trash can off and cut it to length to fit where the stock box went and made some measurements as to where the MAF opening should go - and used an "Exacto" knife to cut the opening. And once you have it fittign over your MAF, you then trim the sides to fit against the inside of the hood. Once you have the trash can it's not hard to do - just a couple of hours of measuring and some cutting, etc.</p></blockquote><p></p>
[QUOTE="Robert Francis, post: 8611660, member: 3393"] If you're talking about the "trash can" air box, theres not much too it. I've made a couple up over the past 6-7 years. I used a "Rubbermaid" trash can - don't recall the size - but you can tell the right size by looking at one. With the stock air box removed it's not hard to visulize how to make the trash can fit in there. I already had removed my stock airbox and had a cone filter adapter on my MAF. I just cut one side of the trash can off and cut it to length to fit where the stock box went and made some measurements as to where the MAF opening should go - and used an "Exacto" knife to cut the opening. And once you have it fittign over your MAF, you then trim the sides to fit against the inside of the hood. Once you have the trash can it's not hard to do - just a couple of hours of measuring and some cutting, etc. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Lightning Forums
2nd Generation
trashcan heat shield mod
Top