TR6060 swap into MT82 car

[DeepimpactGTCS]

I found a good deal on a TR6060 and am looking to put it into my 2013 with the mt82 but I'm not sure what all is different. I will get the tranny clutch and shifter with the purchase. Does anyone know what else is require for the swap? Drive shafts the same? Does it plug and play with any electronics connected to the mt82? The tr6060 is out of a 2011 Shelby

Thanks for any help

 

[BlackMamba3]

The only person I know of that did this did it to his 2012. He got the install completed but the wiring was all jacked up and his speedo either didn't work or was off by a lot. Me personally, I wouldn't go this route but if you're getting a good deal then try it out. Magnum XL might be a better choice though.

 

[manolith]

Is the input shaft on that 10 or 26 spline? Either way you will need a new clutch.

 

[DeepimpactGTCS]

Yea that's the problem it's a smoking deal but I wasn't sure what all would/wouldn't work

 

[mustang_guy]

Any update?

 

[blackbeast12]

You will need the tranny mount a driveshaft a clutch bellhousing, speedo correction basically everything listed here:

TREMEC MAGNUM XL S197 CONVERSION SPECIAL **FREE SHIPPING** - Justin's Performance Center

 

[mustang_guy]

Figured. Probably will cost close to the same thing as a new magnum when all said and done

 

[mustang_guy]

One more question. Will the stock TR6060 clutch work with a TR6060 tranny joined with a 2011-2013 GT?

 

[darreng505]

You will need a speedo convertor box/harness and a new driveshaft as well...