Ive been reading tobynt thread when he did his TT kit. Flawless install.
http://www.svtperformance.com/forums/showthread.php?826230-Tork-Tech-Terminator-Install
I was going to vent both my valve cover vents to my Moroso oil breather catch can. His was a Jegs brand. But basically the same thing.
I began the tear down a couple days ago. I pulled my valve covers off to paint up slick.
I noticed that the passenger side vent has a sensor wire attached with a check ball inside. Pretty sure this is the PCV valve?
Question, this is supposed to route to the back of the blower. If I route this to the breather can, will this throw a code and cause my check engine light to come on?
Thanks for any insight on this.
http://www.svtperformance.com/forums/showthread.php?826230-Tork-Tech-Terminator-Install
I was going to vent both my valve cover vents to my Moroso oil breather catch can. His was a Jegs brand. But basically the same thing.
I began the tear down a couple days ago. I pulled my valve covers off to paint up slick.
I noticed that the passenger side vent has a sensor wire attached with a check ball inside. Pretty sure this is the PCV valve?
Question, this is supposed to route to the back of the blower. If I route this to the breather can, will this throw a code and cause my check engine light to come on?
Thanks for any insight on this.