I have an aluminum Teksid block for sale. $375
Stock bore (will need to be atleast honed or bored .020 to clean up)
SCT BA2400 $sold!
I also have a few pulley rings:
8lb lower........ $75
6lb lower.........$75
3.2 SFPHQ Upper pulley (non slip interchangable ring only)..$40
4.6 4v timing cover (96-98 Cobra, 93-98? mark8)...$75
4v cam covers for B heads........$50
4.6 DOHC heads (B heads)...$75pr
Cast 6 bolt crank...$50
I also have a Low milage stock rebuilt 4R70W out of a 94 Mark8. I Bought car wrecked, The info was given by previous owner. I Pulled the pan and it was was very clean inside, with fresh looking and smelling fluid. ......$250 (I am not asking too much for it because I do not KNOW the history of it. I can only pass on the info that was given to me.)
Two stock 03 Cobra aluminum flywheels.......$75ea
One 99-04 28spl axle (stock)..$50
Two 94-98 28 spl axles (stock)...$50ea
10.5" 10 spl spec stage 3 clutch. About 5000 miles on it. $100
One of the Cobra flywheels:
Spec stage3
__________________
Stock bore (will need to be atleast honed or bored .020 to clean up)
SCT BA2400 $sold!
I also have a few pulley rings:
8lb lower........ $75
6lb lower.........$75
3.2 SFPHQ Upper pulley (non slip interchangable ring only)..$40
4.6 4v timing cover (96-98 Cobra, 93-98? mark8)...$75
4v cam covers for B heads........$50
4.6 DOHC heads (B heads)...$75pr
Cast 6 bolt crank...$50
I also have a Low milage stock rebuilt 4R70W out of a 94 Mark8. I Bought car wrecked, The info was given by previous owner. I Pulled the pan and it was was very clean inside, with fresh looking and smelling fluid. ......$250 (I am not asking too much for it because I do not KNOW the history of it. I can only pass on the info that was given to me.)
Two stock 03 Cobra aluminum flywheels.......$75ea
One 99-04 28spl axle (stock)..$50
Two 94-98 28 spl axles (stock)...$50ea
10.5" 10 spl spec stage 3 clutch. About 5000 miles on it. $100
One of the Cobra flywheels:
Spec stage3
__________________
Last edited:
