Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Cobra Forums
The Terminator
Interior and Exterior Body & Chassis
Swapping seats??
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="04Mach1Blurr" data-source="post: 12367478" data-attributes="member: 92273"><p>I've done this mod to my friends 1998 gt with a power driver seat. I removed both seats, pulled out the power seat box out of the drivers seat which was a much smaller box than our new edges. I simply cut a small enough hole in the passenger seat to fit the controller cable in and glued it to the fabric in back of the controller. You can swap over the seat belt holder on the head rest as well, but i did not take the time to see if I could do the same with the seat latch on the side. </p><p></p><p>The only way your really going to see if you can fab it up is if you remove both seats and put them side to side and make some measurements and develop ideas for it. The other potential problem is removing the lumbar support and side bolsters controller. Maybe it is easier to just switch skins and then make a hole for the side bolster controller.</p></blockquote><p></p>
[QUOTE="04Mach1Blurr, post: 12367478, member: 92273"] I've done this mod to my friends 1998 gt with a power driver seat. I removed both seats, pulled out the power seat box out of the drivers seat which was a much smaller box than our new edges. I simply cut a small enough hole in the passenger seat to fit the controller cable in and glued it to the fabric in back of the controller. You can swap over the seat belt holder on the head rest as well, but i did not take the time to see if I could do the same with the seat latch on the side. The only way your really going to see if you can fab it up is if you remove both seats and put them side to side and make some measurements and develop ideas for it. The other potential problem is removing the lumbar support and side bolsters controller. Maybe it is easier to just switch skins and then make a hole for the side bolster controller. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cobra Forums
The Terminator
Interior and Exterior Body & Chassis
Swapping seats??
Top