Supporting Mods for a 2.70" Pulley Swap?

[CobraActual]

Hey guys just bought my '03 Terminator (all stock) but i'm pretty new at this and had a few questions as far as my setup will be when i order everything:

Metco 2.70" Pulley
Metco Double bearing Idler set (one 90mm & three 100mm)
60 lb injectors
AFCO Double Pass Heat Exchanger
JLT CAI
and ofcourse a tune

Any other ideas you guys have to support the swap?

thanks!

 

[autoxstang]

Mass air meter (SCT) or you can use a MAFia (diablo sport). Stock injectors will probably be ok but, if you want to add more mods later on I would just add a BAP to your injector purchase. Good luck.

 

[greenflash00]

I have the 2.76 on my car and didn't upgrade the MAF or fuel system yet at all but it's not too far from needing it. Tuner said it was fine. I've seen some cars that need it and some that seem to be ok without it. It certainly wouldn't hurt at all. I actually have those parts bought now but haven't installed yet.