How did you support your transmission without a transmission jack to get this installed?
The instructions say to support it with a floor jack and not to use the pan. The issue is the only spot I can find to lift it is right near the front of the bell housing.
EDIT: I gave up and supported it from the rear of the pan near the tail of the transmission. I don't think there is any other way though I would love to hear about it if there is. If I had lifted it from there to begin with this would've taken half the time it did since it popped out of alignment when I removed 2 out of 3 bolts that mate the transmission to the bracket that sits in the k-member.
The instructions say to support it with a floor jack and not to use the pan. The issue is the only spot I can find to lift it is right near the front of the bell housing.
EDIT: I gave up and supported it from the rear of the pan near the tail of the transmission. I don't think there is any other way though I would love to hear about it if there is. If I had lifted it from there to begin with this would've taken half the time it did since it popped out of alignment when I removed 2 out of 3 bolts that mate the transmission to the bracket that sits in the k-member.
Last edited:
