I have a dragon throttle body installed and have the stock black plastic pipe attached to it. I just picked up a steeda intake and the stock air tube is a bit of a stretch to connect. The steeda intake doesn't want to sit in the rubber mounts properly (it sits in the same rubber mounts as the stock intake) - because it's a bit of a stretch it is pulling out of the mounts and I'm not getting proper hood clearance. Does anyone have this setup? Or do you guys know of a place that might sell a spacer or anything like that? Otherwise I'm going to sell this one and try something else. I had the steeda on my old cobra with the stock pipe and an accufab and it fit just fine.
Thoughts?
Thoughts?
