Started tear down for the 2.8 Kenne Bell
- Thread starter blwn03sonic
- Start date
Evanflow head cooling mod in. View attachment 1484203
Parts that need to go in. Still waiting on a few more parts.
Sent from my iPhone using the svtperformance.com mobile app
Sent from my iPhone using the svtperformance.com mobile app
Got this from a member on here. Clean looking piece.
Sent from my iPhone using the svtperformance.com mobile app
Sent from my iPhone using the svtperformance.com mobile app
Good start!
Almost ready. Need a belt and burp the cooling system.
Catch can. Bracket need to be redone later
Sent from my iPhone using the svtperformance.com mobile app
Catch can. Bracket need to be redone later
Sent from my iPhone using the svtperformance.com mobile app
Shes running . Coolant burped. Just need to wire up bap with 40 amp upgrade change the oil and my tune is set for Saturday.
Sent from my iPhone using svtperformance.com
Sent from my iPhone using svtperformance.com
80 lbs
Sent from my iPhone using svtperformance.com
Sent from my iPhone using svtperformance.com
- Joined
- Aug 8, 2017
- Messages
- 34
In also installing a KB 2.8! Buying similar stuff! I see you have pullies, did you buy a tensioner?
Stock one for now
Sent from my iPhone using svtperformance.com
Sent from my iPhone using svtperformance.com
- Joined
- Aug 8, 2017
- Messages
- 34
What size idler pullies did you get, three 100s and a 90? What pulley are you running on the KB? Did you install new gaskets for your intakes? Sorry I have alot of questions.
I’m running billet flow 3 100’s 1 90
3.75 pulley
Replaced the gasket for the blower to intake
Sent from my iPhone using svtperformance.com
3.75 pulley
Replaced the gasket for the blower to intake
Sent from my iPhone using svtperformance.com
She made 591 at 17lbs Of boost. Not bad. With a vacuum leak. Fuel system and smaller pulley next.
Sent from my iPhone using the svtperformance.com mobile app
Sent from my iPhone using the svtperformance.com mobile app
Users who are viewing this thread
