Splitter on our L

[sonic_whine2003]

Hello everyone, I tried looking to see if this was discussed before, but had no luck finding anything.....Does anyone know what splitter is being used in the photo? Or can you tell me any that u have used.....I like the look and just want to stand out a little.

 

[sonic_whine2003]

BTW I know I'd have some fab work to get it installed since they don't "make" one for our trucks....just need to know which splitter it is.

 

[Dusten]

Looks like a gt500 piece

 

[4a7191a]

Makes the truck look lower too. I likes

 

[sonic_whine2003]

Looks like a gt500 piece

That's what I thought but I don't think it is...The middle of the lip in the pic steps up and when I look at the gt500's the middle steps down

 

[sonic_whine2003]

Makes the truck look lower too. I likes

Yeah exactly....I love the look

 

[sonic_whine2003]

I think I found it fella's what do you all think is it a match? 11-14 Roush splitter

 

[Dusten]

I personally think it looks like shit. Its lines are for the mustang bumper and do not mesh with the lightnings at all.

 

[sonic_whine2003]

That's the beauty of America....If one doesn't like something one might and it doesn't matter.....Hent's I don't like gassers but others love em

 

[Dusten]

You asked if you thought it was a match, I misunderstood, hence my comment. Its probably the same splitter. Best of luck

 

[sonic_whine2003]

No issue here....to each their own

 

[mizlplix]

We always used 1/2" hardwood plywood on the racecars because they got nerfed every time you off roaded. (Plowed the gravel pits)

Leave the lower edge sharp 90 deg. and round off the upper edge radically so the air shears when it goes under the vehicle.

Sand, 2-coats of clear, then 2-coats of black. (With a light 600 grit sanding between coats) a 1500 wet sand and wax to finish

and it will look like smooth plastic. (and cost almost nothing)

Miz

 

[mizlplix]

K-Design's R-1 splitter is mentioned over on the LR forums.

Miz