So I'm getting ready to install my return setup and just want to make sure I'm clear on the wiring. I have a fore level 2 kit and I want it to prime just like normal using the FPDM. So I followed this thread but just want to make sure I'm understanding correctly.
https://www.svtperformance.com/thre...-allowing-oe-type-fuel-pump-actuation.825181/
So I have FC2 controller. Wire the pumps in to Pump 1 and 2 locations. Battery and chassis ground are easy. Based off this pic below I'd run Pin 10 to the remote on the FC2 and then what about Pin 3? Says ground but not chassis ground? Does it go like this pic to the FC2?
I know this says pin 9 ignore it. I stole the pic from another thread.
https://www.svtperformance.com/thre...-allowing-oe-type-fuel-pump-actuation.825181/
So I have FC2 controller. Wire the pumps in to Pump 1 and 2 locations. Battery and chassis ground are easy. Based off this pic below I'd run Pin 10 to the remote on the FC2 and then what about Pin 3? Says ground but not chassis ground? Does it go like this pic to the FC2?
I know this says pin 9 ignore it. I stole the pic from another thread.