Finally finishing everything up with the build on the new motor. Ditched the Race bullets with turndowns, and went with Stingers after encountering a good deal. No issues with the install. ARH 1-3/4 x 3" headers, 3" Xpipe all way to the ball connector which is 2.5, fitment is both awesome on the headers, and Xpipe, and stingers.
Disregard the condensation in the exhaust, it was -2 degrees here in Alaska when I backed the car out. Startup, and idle clip. Waiting on the snow to melt so I can get some break-in time, then some dyno time. Car should make close to 800, maybe a tad more if everything goes as planned.
https://www.youtube.com/watch?v=vOqTUFHC-Qs
Disregard the condensation in the exhaust, it was -2 degrees here in Alaska when I backed the car out. Startup, and idle clip. Waiting on the snow to melt so I can get some break-in time, then some dyno time. Car should make close to 800, maybe a tad more if everything goes as planned.
https://www.youtube.com/watch?v=vOqTUFHC-Qs
Last edited: