slight chirp?

[SVTCLOPTON]

I just installed spec 3+ clutch, the car has 26spline input shaft install new ford racing heavy duty throwout bearing, steel flywheel, it has clutch cable. Installed 2 months ago and now I hear this slight chirp taking off. It only happens taking off from a stop after that its gone. :shrug:

 

[Senkak]

Have you adjusted the clutch cable to make sure the PP finders aren't riding on the TOB.
This will wear out the TOB in a hurry.
The chirp is usually the the first sign of a TOB starting to go bad.
Unfortunately these cars like to eat them.

 

[03SVTCOBRA10TH]

Yup TOB is chirping, get the LDC clutch free play MOD!!!

 

[3Dglasses]

I'm thinking about going with a steel flywheel.. What is your impression?

Also, yea, the TB starts to make noise B4 it goes. I have the free play mod and it is easy to install. Unfortunately I installed it way too late and will be doing my TB next week. Considering just swapping the stock clutch (40k miles) and a steel flywheel. I do not drag race, but AutoX regularly..

 

[Senkak]

If you don't drag race stick with the aluminum FW.
It will allow the motor to rev easier due to less mass of the FW to turn.

 

[03SVTCOBRA10TH]

Above is correct, Aluminum flywheel for autoX, steel for drag!!!!

Go with a twin disk.

 

[SVTCLOPTON]

I went with the steel flywheel its better for the street but I like the fact that you can replace the center instead of the whole flywheel much cheaper. I heard you only gain like 5 hp going with a aluminum? thanks for the input also guys!