SES light on with MIL eliminators?

93Coupe

New Member
Established Member
Joined
Aug 23, 2004
Messages
269
Location
Texas
this past weekend i installed my Bassani o/r X w/ MIL's and Mac 3" cat-back. first off i will say it sounds awesome and is a lot louder than i expected and as i was told in the other thread i did lose some low end power but top end it seems a lot stronger. anyways, i installed the MIL's and the SES light was off until i drove around for awhile and then came on. i dont understand why its on with the MIL's hooked up? any help would be appreciated

thanks
 

01SVTSnake

Thud Thud Thud Thud Thud
Established Member
Joined
Mar 11, 2007
Messages
6,226
Location
SE PA
could be another code unless the code you pulled (if you did) was for rear 02s. It is also possible that one of the MILs could be bad or that the wire came into contact with the pipe and burned.
 

Predatorbird

Active Member
Established Member
Joined
Jun 22, 2007
Messages
3,139
Location
Florida
could be your upstream o2's. my ses light came on after 500 miles due to these sensors. i replaced them w/ factory o2's and the light still came back on.
 

jlauth

Active Member
Established Member
Joined
Nov 19, 2005
Messages
1,286
Location
Indianapolis
I have had this problem for so long! I assume my mils took a shit, but i have returned them once already. I like you dont want to change all of my O2s and have that not work either. I am so stumped on this subject.
 

Users who are viewing this thread



Top