Sold off my all tan interior for some 2 tone Black and Tan setup. Also installed 2001 Bullitt seats and wanted something to replace the rear seat so I called up Scott Rod Fab for one of there SN95 rear seat delete without the headrest panel. This is what came in the box 3 days later...
With my supercharged car I have a external T Rex fuel pump that makes a good amount of noise so I wanted to mask it as much as possible to I bought 2 can of Rustoleum profecianal undercoating and whent to town on the back sides of them.
After I let them dry I started the install, they do not come with instructions so a quick call to Scott Rod Fab had it figured out. 1st is to set the passenger side upper panel in and secure it with 3 rivits. 1 in each corner except for the lower right corner.
Next move to the driver side upper panel and this is where you will need to trim to fit Messure twice cut once!!!!!
This time put a rivit in each corner and move to the lower passenger side panel set that in place an this it where one of the lower button supports come in. Use masking tap on the 1/4 plastic to show where the lower bottom will stay and remove the panel. Set the support in and rivit it flush with that tape line. Now the lower panel will pay on that and can be rivits in.
Next move to the driver side lower panel and do the same.
Now that everything is in and trimmed to fit correctly Messure out with tape and mark where the rest of the rivits go and then go to town!!!
I think it came out supper nice and even though it was a lot more the other RSDs ($311 shipped) it is well worth it!
With my supercharged car I have a external T Rex fuel pump that makes a good amount of noise so I wanted to mask it as much as possible to I bought 2 can of Rustoleum profecianal undercoating and whent to town on the back sides of them.
After I let them dry I started the install, they do not come with instructions so a quick call to Scott Rod Fab had it figured out. 1st is to set the passenger side upper panel in and secure it with 3 rivits. 1 in each corner except for the lower right corner.
Next move to the driver side upper panel and this is where you will need to trim to fit Messure twice cut once!!!!!
This time put a rivit in each corner and move to the lower passenger side panel set that in place an this it where one of the lower button supports come in. Use masking tap on the 1/4 plastic to show where the lower bottom will stay and remove the panel. Set the support in and rivit it flush with that tape line. Now the lower panel will pay on that and can be rivits in.
Next move to the driver side lower panel and do the same.
Now that everything is in and trimmed to fit correctly Messure out with tape and mark where the rest of the rivits go and then go to town!!!
I think it came out supper nice and even though it was a lot more the other RSDs ($311 shipped) it is well worth it!
