Roush extreme lowering springs

[Skrapmetal]

Went through the entire pic thread and I didn't see anyone that was sporting the Roush springs. I've got some sitting here waiting for my panhard bar to show up to install all at once.

Anyone using these have some pics so I can see what I've got in store with these springs stance-wise?

 

[SC2011GT]

Not a very good picture, but it is all I have. I didn't need a panhard bar, either. Rear end was within .04" of square (four hundredths).. Just required some small camber correction.

 

[Chuck@Evolution]

Hope these help.

<a href="https://picasaweb.google.com/lh/photo/V9pNYHSflXFEwPKpprTezZLn4yeSeoQtYU2jvnRfIjI?feat=embedwebsite"><img src="https://lh6.googleusercontent.com/-taVjKSNPymo/TaD3iEnRbKI/AAAAAAAAABc/Xqb7X90m_cc/s640/IMG_20110409_142251.jpg" height="480" width="640" /></a>

<a href="https://picasaweb.google.com/lh/photo/iG_tKyhzQVV0hqYYCdFbTpLn4yeSeoQtYU2jvnRfIjI?feat=embedwebsite"><img src="https://lh4.googleusercontent.com/-axxOYXqc6Vs/TaD3l-VAicI/AAAAAAAAABg/TPDYKek9nQ4/s640/IMG_20110409_142204.jpg" height="480" width="640" /></a>

<a href="https://picasaweb.google.com/lh/photo/r-ltvfLxk9PNMvZ6WWwy9JLn4yeSeoQtYU2jvnRfIjI?feat=embedwebsite"><img src="https://lh4.googleusercontent.com/-vCcStlssMQk/TemBVtyo9LI/AAAAAAAAAEQ/BiYu053DGQA/s640/IMG_20110603_202335.jpg" height="480" width="640" /></a>

 

[Skrapmetal]

Not a very good picture, but it is all I have. I didn't need a panhard bar, either. Rear end was within .04" of square (four hundredths).. Just required some small camber correction.

Pic isn't showing up. Your link isn't directly to the image file. I tried to load the album myself but I'm not having any luck on my phone

 

[Skrapmetal]

Thanks Chuck! Are you running the stock shocks?

 

[Chuck@Evolution]

Yup, stock shocks all the way round. I like the way it rides, not too harsh.

 

[SC2011GT]

I'm also running the stock shocks. I opted NOT to replace the rear end bump stops as well.

 

[aquill1]

SC2011GT
I bought a set used and they didn't include any bumpstops or anything with it. Will I need anything else to install them? I was planning on getting the Eibach camber bolts just in case the camber needs to be adjusted.

 

[BlkCoyote]

Im running on the Roush's as well on stock shocks, just make sure you get a good alignment done after , your toe settings will be out of spec after the install.

 

[SC2011GT]

All you need is the springs. My kit came with some rear bump stops, but I didn't see any need for them so I didn't use them. I didn't need any camber plates, or bolts, or panhard bar, etc. I threw the springs in, took it in for alignment and they easily got the camber/toe where it needed to be and the rear end was square soooo..

My suggestion is put em' in, and go get it aligned.