Rescued Cobra engine front assembly help

[jacek]

Hello, thank you for having me here. I have just rescued a 2001 convertible sitting outside for many years. Apparently the timing cover was removed to replace the timing chains. It was never assembled back. I managed to assemble the engine but few questions remain:
1. The top right bolt on the right bank holds a small black sheet metal bracket. How shouldn't it be oriented and what is it's purpose?
I attached pictures for clarity
2The ac line going to the condenser has a Hook shaped.bracket that seems to be attached to the nearest timing cover stud but it is a hard line and seems quite far from the stud. I don't want to start bending it until I'm sure that is where it goes. Picture attached as well.
3I have a left over bracket that seems to hold either a 1/4" or so wiring harness or tubing but could not figure out where it goes. Maybe someone here will recognize it.
Pic attached hed as well.
Thank you for your help!!!

 

[01yellercobra]

1) Can you take a wider shot? I'm not sure what bracket would go there.

2) You can just bend the bracket to reach the stud. I bent that bracket many times in my Procharger days.

3) I think that's for a power steering line. It would bolt to the bottom of the pump IIRC.

 

[jacek]

Thank you.
This is the top outer right bank timing cover bolt. I saw this bracket on it in a picture online. The bolt has an m8 stud in it. I am not sure if the bolt or the bracket go there but it did in the pic i saw. Marked pic attached.

 

[jacek]

Never mind there is a clip in the harness right next to it. It fits perfectly

 

[52merc]

1) You can bend it as said previously.

2) You got it. The Christmas Tree retainer pushes in there. Damn, I thought my engine bay was pretty clean.

3) I need to look more for this.