I just replaced all the bearing and races in my rear end and this is the pattern I am getting.
DRIVE SIDE:
http://spectrum-photo.com/gearp1.jpg
COAST SIDE:
http://spectrum-photo.com/gearp2.jpg
I have been looking at all of the pattern charts and I am unsure if this is acceptable. If the pinion depth is too shallow, I have heard 0.30 is standard, so how small of a shim can I use? The backlash is at 0.12 and I used the same sized pinion shim (an 0.28). It is an Eaton posi with 4.30 gears (unsure of brand)
Thanks,
Dave
DRIVE SIDE:
http://spectrum-photo.com/gearp1.jpg
COAST SIDE:
http://spectrum-photo.com/gearp2.jpg
I have been looking at all of the pattern charts and I am unsure if this is acceptable. If the pinion depth is too shallow, I have heard 0.30 is standard, so how small of a shim can I use? The backlash is at 0.12 and I used the same sized pinion shim (an 0.28). It is an Eaton posi with 4.30 gears (unsure of brand)
Thanks,
Dave