Started installing Nick's bushing kit today. I removed that tacked welded washer, like the MM instructions say, and there is plenty of room for the crush sleeve. Is that right? I test fit the lower control arm in place and it doesn't seem like i should have to straighten out the tabs. I didn't tighten it down just set it in there and eyeballed everything and it looked like it would be ok. I need specifics in this area please. I've planned out this install and researched it for a month or two and it has gone smoothly so far, just time consuming. Basically doing everything by myself, unless its heavylifting then my dad helps.
Thanks guys
Brent
Thanks guys
Brent