Question for those with Ford Racing 96-04 Mustang Dual-Guage Dash Pod

[BlownReptile]

Im about to pull the trigger on some mods, and I wanted to get a good gauge setup. I'm looking at going with a triple pillar pod and the dual dash pod that sits where the clock used to be on earlier mustangs. Here is the pod-

http://www.lethalperformance.com/pa...racing-96-04-mustang-dual-guage-dash-pod.html


Apparently you have to cut into the dash to install this pod, which I would prefer not to do. Anyone manage to attach it to the dash without having to cut? I cant tell if it has a solid bottom- I was thinking of using some 3m tape or something similar to stick it on my dash and avoid carving up my interior.

 

[WowGuySVT]

I'm not sure, but I think the reason you cut the dash would be so you can run the lines to the gauges and keep them as discreet as possible.

 

[BlownReptile]

Hm good point.....I wonder if drilling a small hole would be possible

 

[WowGuySVT]

yea, you are going to have to drill some sort of hole for your power/ground wires, and the actual feed to whatever gauge you are putting there. Just get a 3 gauge pod...what more guages do you want?

 

[sunburned]

I say get this instead of the dash pod. No drilling and much easier to run the wires.

http://www.lethalperformance.com/pa...04-mustang-dual-instrument-cluster-bezel.html