Pulley Puller from Kenne Bell Performance

[CobraSpit]

Kenne Bell Performance say they have a pulley puller that will remove the "stock" pulley from the Eaton supercharger on my '03 Cobra without damaging or marring the stock pulley. They also claim that I can put the stock pulley back on when I need to without any problems. Has anyone out there ever used a Kenne Bell Pulley Puller, and what results did you have with it?

CobraSpit

 

[dougwg]

When you pull the stock pulley off you must not only, NOT mar the Pulley but you must also must NOT mar the face of the Blower Shaft!

Amazon Racing did about 5 pulley swaps at Ennis, Texas this past weekend. There was an absolute minimum of evidence in the form of marring.

If you use The NEW Amazon Racing Pulley Puller and Install tool, it will be extremely difficult for a service rep to be able to tell if a swap was done.

I have some pic’s I’ll post up later today.

 

[Killer Cobra]

Yeah please do post this. I haven't see a good "How To" yet. Who has a good write up on removing/installing the stock pulley and stuff?

 

[jream]

socalcobra did an excellent write up...

http://www.svtperformance.com/forums/showthread.php?s=&threadid=20090