Here ya go
Pics of my 4" MAF-TB pipe
- Thread starter viperbluelx
- Start date
another
That looks fantastic. :thumbsup: Where did you get it?
It's homemade. I ordered the parts from Air Flow Systems Inc. Can't remember the web address. But anyways you just need a 4" to 4" rubber elbow and a 4" to 3 1/2" reducer. I picked up the breathers in the ricer section at Advance Auto parts
http://www.airflo.com/
That is a pretty inexpensive setup that still looks fantastic. What did you use between the elbow and the reducer?
That is a pretty inexpensive setup that still looks fantastic. What did you use between the elbow and the reducer?
Oh yeah, 4" aluminum pipe sold by the same place. It comes in like a 14" section, but you only need about 6". I painted it gloss black with krylon.
the fabrication took all of 15 minutes
did u get any increase power with that.
Never had the car dynoed, but there is a seat of the pants difference above 5,000RPM's. Seems to pull a lot smoother up to 7,000
Where did you get the valve cover breathers?
advance auto parts in the ricer section, they push in
Users who are viewing this thread
