permatex epoxy

[98ABcobra]

i bought permatex permoxy epoxy for plastics rated up to 250degrees. is this the stuff needed to fill in the imrc holes or should i get different stuff?

 

[WaffleGT]

i bought permatex permoxy epoxy for plastics rated up to 250degrees. is this the stuff needed to fill in the imrc holes or should i get different stuff?

JB Weld I would say. Or best way is to TIG weld them:coolman:

 

[SVTContique]

JB weld.

 

[STAMPEDE3]

98 are not aluminum,

Epoxy works but not sure which one.
Hopefully someone with a 98 who did theirs will chime in.

 

[Cookieman00x]

JB Weld Industrial... or have it welded..

 

[WaffleGT]

JB Weld I would say. Or best way is to TIG weld them:coolman:

:bash: Opps..forgot to look at the year

 

[Cookieman00x]

:bash: Opps..forgot to look at the year

You can always get the aluminum one's

 

[MGC-STCK]

if your imrc are plastic it will be ok. do one and after it dries put it in the oven at 220-240 then after 30 mins or so poke them if epoxy holds up then your good. i have a 96 cobra (metal imrc) and when i used epoxy and did the test the epoxy holded up but when i poked it would start coming out. so i turn to JB weld, that worked the best