People who installed their line locks

[blackfang]

Did you have to remove the master cylinder? I am looking at getting one but not sure if the hassle is worth it.

 

[19mustang95]

i did not, but my motor wasn't there..

 

[coolguy10786]

Who makes a line lock for our cars?

 

[Gallows]

Hurst makes one http://www.hurst-shifters.com/catalogpdf/3-Roll-Control/RollContrl.pdf

 

[94CobraPace]

No need to remove the master cylinder. I have a hurst roll control.

 

[coolguy10786]

I've been doing some searching and have found that with the 3 channel abs you have to use two solenoids. Anyone know how you would go about setting that up?

 

[Gallows]

I never heard of that before. I was going to pick up a used one in the Market off of a 99/01 Cobra and he only had one on the car:shrug: On 98's I think you need different fittings.

 

[coolguy10786]

From what i've been reading, some of the 98s have the same 4 channel abs that the 99+ mustangs have, which allow you to run just one solenoid.

 

[Gallows]

Okay i'm lost again:lol1:

 

[coolguy10786]

Well im trying to figure it out too lol. Sounds like they don't give you the needed fitting no matter the year. Sounds like you cut the old line and reuse the fitting on that one.

 

[blackfang]

Bitemark posted up a good reply to my thread on MF.

http://www.modularfords.com/forums/showthread.php?t=104519