http://s43.yousendit.com/d.aspx?id=12JW97NE4NL181OSMGPM10GCET
Been told twice now this is not suppost to happen.
Anyone wondering what this is, you're looking at the races for the input shaft and counter shaft.
I'm told when they're seated they're not suppost to move at all but as you can see they do.
trans has 8k miles, never been ran, nothing.
I also have a problem with tremecs factory specs.....
Counter shaft is very loose(so it seems) and i thought it should be pretty close(factory was around .007 off from spec if i'm understanding this correct).
My input shaft was also off spec(.000 - .002 is spec)(when i checked it was around .013 from the factory).
Would this have caused the races to turn as shown in the video?
I honestly can't believe this if i'm understanding this correct, how could they be so far off with these specs?!?!
Been told twice now this is not suppost to happen.
Anyone wondering what this is, you're looking at the races for the input shaft and counter shaft.
I'm told when they're seated they're not suppost to move at all but as you can see they do.
trans has 8k miles, never been ran, nothing.
I also have a problem with tremecs factory specs.....
Counter shaft is very loose(so it seems) and i thought it should be pretty close(factory was around .007 off from spec if i'm understanding this correct).
My input shaft was also off spec(.000 - .002 is spec)(when i checked it was around .013 from the factory).
Would this have caused the races to turn as shown in the video?
I honestly can't believe this if i'm understanding this correct, how could they be so far off with these specs?!?!
