noise after intake manifold install

Dark02Pony

Member
Established Member
Joined
Nov 20, 2005
Messages
461
Location
Parsippany, NJ
Just installed the typhoon manifold from american muscle yesterday. Popped the hood today to check for any leaks since by the time I finished yesterday I was too damn tired. Idle is normal, runs extremely smooth and I couldn't be happier with this manifold. I did find when I hit the throttle linkage slightly then let go n let the rpm's drop back down to idle that I get a whoosh from around the plenum area. I was able to recreate this by simply pulling the connector off of the IAC then plugging it back in. The whoosh lasts roughly 15 seconds after returning to idle. Any ideas ? I was sure to crank down on all of the bolts and reconnect the proper lines.
 

2002 SN95 GT

New Member
Established Member
Joined
Oct 11, 2011
Messages
5
Location
indiana
it's an aluminum pi intake, should be same as stock, bottom can unbolt for porting
 
Last edited:

Users who are viewing this thread



Top