Need help installing corbeau harnesses!!!

[DevilDog81]

I have an 03 terminator convertible and just bought corbeau seats. I'm trying to figure out how to set up the harnesses since I don't have a roll cage, I only have the CDC light bar. I haven't purchased the harnesses yet.

Pictures are worth 1000 words, if you have them.

Thanks

:shrug:

 

[Dragu1a]

i'm at work now, so i don't have any pictures. i bought the corbeau harness bar, so the 2 shoulder straps get wrapped around that...without that, i'm pretty sure they're just bolted to the floor, but i'm of no help with that.

the 2 straps around the hips bolt in to where the oem seatbelt and buckle are.

i did not do the 5th slot between the legs.

 

[oldmodman]

Never run a harness that is bolted to the floor. It must always be attached to either a cross bar in a cage (at the correct shoulder height) or to a harness bar.
If it is attached to the floor your spine can be crushed in a crash. Even if the harness is fed through the slots in a "racing seat" there is still too great a chance that the force of the crash will still cause the harness to tear through the seat and pull your shoulders straight down collapsing your spinal column.

 

[DevilDog81]

thanks for the info.