Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Cobra Forums
The Terminator
Engine/Tuning
MSD-8969 Window Switch
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="NVRL8TE" data-source="post: 15329916" data-attributes="member: 142298"><p>I have an MSD-8969 and want to know where I should get my ECM tach signal from.</p><p></p><p></p><p></p><p></p><p>I think I should do it the way the instructions state, as follows...</p><p></p><p></p><p>5 volt conversions</p><p>and pin locations</p><p>On many DIS applications, you</p><p>can connect the White wire to</p><p>the ECU Tach Output. Following</p><p>are suggested Pin locations. It</p><p>is recommended to have your</p><p>vehicle's factory service manual or</p><p>wiring schematic.</p><p></p><p></p><p>I just don't know where I should be attaching the white wire from the MSD-8969...</p><p></p><p>I'm assuming I should be doing this, as shown on page four (the last wiring diagram...)</p><p></p><p><a href="https://www.jegs.com/InstallationInstructions/100/121/121-8969.pdf" target="_blank">https://www.jegs.com/InstallationInstructions/100/121/121-8969.pdf</a></p><p></p><p>I hope someone has done this, and thank you in advance.</p></blockquote><p></p>
[QUOTE="NVRL8TE, post: 15329916, member: 142298"] I have an MSD-8969 and want to know where I should get my ECM tach signal from. I think I should do it the way the instructions state, as follows... 5 volt conversions and pin locations On many DIS applications, you can connect the White wire to the ECU Tach Output. Following are suggested Pin locations. It is recommended to have your vehicle's factory service manual or wiring schematic. I just don't know where I should be attaching the white wire from the MSD-8969... I'm assuming I should be doing this, as shown on page four (the last wiring diagram...) [url]https://www.jegs.com/InstallationInstructions/100/121/121-8969.pdf[/url] I hope someone has done this, and thank you in advance. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cobra Forums
The Terminator
Engine/Tuning
MSD-8969 Window Switch
Top