I have an MSD-8969 and want to know where I should get my ECM tach signal from.
I think I should do it the way the instructions state, as follows...
5 volt conversions
and pin locations
On many DIS applications, you
can connect the White wire to
the ECU Tach Output. Following
are suggested Pin locations. It
is recommended to have your
vehicle's factory service manual or
wiring schematic.
I just don't know where I should be attaching the white wire from the MSD-8969...
I'm assuming I should be doing this, as shown on page four (the last wiring diagram...)
https://www.jegs.com/InstallationInstructions/100/121/121-8969.pdf
I hope someone has done this, and thank you in advance.
I think I should do it the way the instructions state, as follows...
5 volt conversions
and pin locations
On many DIS applications, you
can connect the White wire to
the ECU Tach Output. Following
are suggested Pin locations. It
is recommended to have your
vehicle's factory service manual or
wiring schematic.
I just don't know where I should be attaching the white wire from the MSD-8969...
I'm assuming I should be doing this, as shown on page four (the last wiring diagram...)
https://www.jegs.com/InstallationInstructions/100/121/121-8969.pdf
I hope someone has done this, and thank you in advance.